Filter
Top Products
H9 ASD Installation and Operation Manual 33
Keypad Remote Mounting
The H9 ASD may be controlled from a remotely-mounted keypad. For safety and application-specific
reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or
that the keypad not be attached to the ASD housing. The keypad may be mounted either with or without
the optional Remote Mounting Kit (P/N ASD-MTG-KIT). The ease of installation is enhanced by the
Remote Mounting Kit (P/N 58333) which allows for keypad placement and easier cable routing.
Remote mounting will also allow for multiple keypad mountings at one location if controlling and
monitoring several ASDs from a central location is required.
The keypad can operate up to 9 feet away from the ASD. A keypad extender cable is required for remote
mounting. The keypad extender cable is available in a 9-ft. length and may be ordered through your sales
representative.
The optional dust cover (P/N ASD-BPC) may be used to cover the front panel opening of the ASD
housing after removing the keypad.
Remote Keypad Required Hardware
Keypad Mounting Hardware
• EOI Remote-mount Housing — P/N 58333 (included with 230-volt 40-HP and above; and with the
460-volt 75 HP and above)
• 6-32 x 5/16” Pan Head Screw — P/N 50595 (4 ea.)
• #6 Split-Lock Washer — P/N 01884 (4 ea.)
• #6 Flat Washer — P/N 01885 (4 ea.)
Bezel Plate Mounting Hardware
• Bezel Plate — P/N 52291
• 10-32 Hex Nut — P/N 01922 (4 ea.)
• #10 Split-Lock Washer — P/N 01923 (4 ea.)
• #10 Flat Washer — P/N 01924 (4 ea.)
• Dust Cover — P/N ASD-BPC (Optional)
Extender Cable
• ASD-CAB10F: Cable, 9 ft.
Keypad Installation Precautions
Install the unit securely in a well ventilated area that is out of direct sunlight using the four mounting holes
of the rear of the keypad. The ambient temperature rating for the keypad is 14° to 104° F (-10° to 40° C).
• Select a mounting location that is easily accessible by the user.
• Avoid installation in areas where vibration, heat, humidity, dust, metal particles, or high levels of
electrical noise (EMI) are present.
• Do not install the keypad where it may be exposed to flammable chemicals or gases, water, solvents,
or other fluids.
• Turn on the power only after securing the front cover to the ASD.