Filter
Top Products
H9 ASD Installation and Operation Manual 41
System Configuration and Menu Options
Root Menus
The Mode key accesses the three primary modes of the H9 ASD: the Frequency Command mode, the
Monitor mode, and the Program mode. From either mode, press the Mode key to loop through to the
other two modes (see
Figure 27). While in the Frequency Command mode, pressing the ESC key
toggles the menu to and from the EOI Command mode and the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen and on the LED screen when active. Fault
information will be displayed via the Fault screen. See
Alarms and Trips on pg. 246 for more information
on Alarms and Trips.
Note: EOI Command mode changes made when accessed via the method shown in Figure 27
are effective for EOI control Only.
Figure 27. H9 ASD Root Menu Navigation.
Frequency Command Mode
Frequency Setting
While operating in the Local mode (Local LED is illuminated on the front panel), the running frequency
of the motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the
Frequency Command value, connect ST to CC, and provide a Run command (F and/or R) and then
press the Run key. The motor will run at the Frequency Command speed and may be changed while
running. See
Figure 22. on pg. 31 and Operation (Local) on pg. 73 for more information on the Frequency
Command mode.