Filter
Top Products
Xerox Document Centre Reference Guide Page 10 - 35
10. Tools
Out Of Staples Option
Complete job without stapling - If this option is selected, the job
will print without stapling. Any remaining sets will be printed
without staples.
Fault/Hold job - If this option is selected, the job will be held until
a staple cartridge is replaced.
Any jobs requiring stapling that have not started will not print. Any
jobs in the process of printing that require stapling will be held and
a fault message will display.
Output Location for Non-Stapled Jobs
A fully featured Document Centre has a Finishing device that
contains two output trays, the top and main tray. This feature allows
you to select the destination of non-stapled jobs. This includes
Copy, Print, and Other jobs.
For example, using this feature you can enable all incoming non-
stapled print jobs to be sent to the top tray.
Within Job Offsetting
When enabled, this feature separates printed sets within a job by
slightly offsetting each set. The feature can be enabled or disabled
by selecting the desired button. The default is enabled.
When the feature is disabled, output copies will be delivered to the
output tray in an even stack. This is helpful when users print large
volume jobs where offsetting is not required. This feature is not
recommended for thin stapled sets (sets between 2 and 15 sheets of
paper).