Filter
Top Products
Page 3 - 12 Xerox Document Centre Reference Guide
Finisher
The Finisher consists of the Top Tray and the Stacker Tray.
The Top Tray receives sheets that are purged from the system. It
can hold up to 250 sheets of small paper. It can be set as a destination
tray for non-stapled jobs. Copies that are less than 6.7 inches long in
the feed direction or 8 inches long in the cross-feed direction will go
to the Top Tray rather than the Main Tray.
The Main Tray is the output tray for all other copies. This tray can
hold up to 2000 unstapled sheets. It has two staplers, each with a
5000 staple cartridge, that can staple sheets ranging in size from 6.7
x 8 inch to 12 x 18 inch of 16 to 110 lb. stock.
To ensure that the stapling of thin sets is satisfactory, the machine
stops after producing between 80 and 100 sets of 2 -15 sheets to
allow you to unload the machine. It automatically resumes printing
after it is unloaded or after one minute. These options are adjustable
in Tools. Refer to page 10-34 for more information.
Some versions of hardware may not require these options.
NOTE
Removing output while the machine is running may produce
finished sets that are incorrectly stapled. To unload the Finisher
while it is printing, Press the Finisher Pause button and wait for the
tray to lower. After you unload, press the button again to continue.
Top Tray
Main Tray
Press the Finisher
Pause Button to
unload Stacker
Tray during a print
run