Filter
Top Products
Page 15 - 8 Xerox Document Centre Reference Guide
Paper
Handling
(cont’d)
Repeated Check Tray
Messages on the User
Interface and the paper is
loaded in the tray
Adjust the edge guides against the stack of
paper in the tray.
If the edge guides were not set against the
paper stock in the tray when Start was
selected, delete the job in the job queue and
begin again.
Paper Curls
Load the paper in the paper trays seam side
of the paper up. Load the paper in the High
Capacity Feeder and Bypass Tray with the
seam side down.
Load non-standard media in the Bypass
Tray.
If the paper curls excessively, flip the paper
over in the applicable paper tray.
The Finisher does not stack
the output correctly
Unload the finisher tray frequently.
Depending on your machine configuration
there may be a pause button on the side of
the finisher.
Do not remove stapled sets while the
finisher is compiling.
The Finisher does not
staple or staple well
The finisher does not staple stacks of more
than 50 sheets of 20 lb. paper.
Use less than 50 sheets of paper if they are
heavier than 20 lb.
Check the User Interface for a fault
message indicating no staples. Replace the
staple cartridge.
Problem Symptom Recommendation
The seam refers to the side of a
ream of paper with a split in the
wrapping. It may also be
referred to as arrow side first.