Filter
Top Products
1-1
Section 1 Fax Operation
(Names of Parts / Preparations /
Features and Functions of this Fax)
Main Body Parts and their Functions
The following contains information on the names and functions of the parts that are required when this machine is used as a facsimile.
Refer to the Operation Guide for your copier for information on other parts of this machine.
z Document Processor
This unit is a duplex document feeder from which you can fax both 1-sided and 2-sided originals.
Names of Parts
(1) Operation panel Use the operation panel to perform the procedures required for fax communication.
(2) Multi-Bypass Paper can be set in the Multi-Bypass as well. In order to use the Multi-Bypass, it is necessary to select
“ON” under “Turning Manual Paper Feed ON/OFF (“Bypass feeding” setting)” on page 7-16. Refer to the
Operation Guide for your copier for more detailed information regarding the use of the Multi-Bypass.
(3) Telephone jack (T) Use this jack to connect a separately purchased telephone to the fax.
(4) Line jack (L) Use this jack to connect the fax to a telephone line using the modular cord.
(5) Main power switch Turn this switch ON ( | ) in order to perform fax and copy operations. The touch panel will light and
operation will be possible.
(1)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(2)
(12)
(6) Document table Set the documents you want to transmit on this table. Up to 100 sheets of up to 11" x 8 1/2" [A4] size
paper, or up to 70 sheets of 8 1/2" x 14" or 11" x 17" [A3 or Folio] size paper, can be set at one time.
(7) Document insert guides Adjust these guides to match the width of the documents.
(8) Document Processor
reversing cover
Open this cover if a document jams.
(9) Document eject cover Documents are ejected onto this cover after being scanned.
(10) Eject guide Open this guide when transmitting documents of a large size such as 8 1/2" x 14" or 11" x 17" [A3 or
Folio].
(11) Document Processor
open/close lever
Operate this lever when opening and closing the Document Processor.
(12) Document set indicator This indicator indicates the status of the documents set in the Document Processor. Documents are set
properly when the indicator is lit green.