Filter
Top Products
Section 3 Fax Operation (Various Functions)
3-8
If you designate in advance the time for a communication to begin, that communication will be carried out automatically once the appointed
time is reached. You can designate a communication to be one that uses the timer during the operation procedure for each of various types of
fax communication available in this fax such as Broadcast Transmission.
The example in the procedure below is for the transmission of documents to a single destination using the timer function.
Note: The time for the communication to begin is based on the time that is set in this machine. Make sure to check the time set in this machine
in advance.
* All transmissions that use the timer will be accomplished in the Memory
Transmission mode even if the fax is currently in the Direct Feed
Transmission mode.
* Each communication that uses the timer can be set to begin at any minute
between 00:00 - 23:59.
* A maximum of 50 communications (including any combination of
communications that use the timer, Interrupt Transmissions and Standby
Transmissions) can be scheduled at one time.
* When 2 or more communications that use the timer are scheduled to begin at
the same time, fundamentally each communication will be accomplished in the
order that they were registered. However, even if it has been registered later,
any communication that scheduled with a single location will take priority over
a communication to multiple locations.
* It is possible to cancel or change the contents of a communication that is
waiting for a start time, (Refer to “Managing Information for a Scheduled
Communication (Editing a Communication in Memory)” on page 3-14.)
* If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
Set the documents you want to transmit in the Document
Processor or on the platen.
* When the documents are set on the platen, it is
necessary, after each page is scanned, to select whether
or not you want to transmit more pages and to select the
size of each page.
(Refer to page 2-6.)
Enter the destination fax number.
* You can enter the fax number using the keypad,
abbreviated numbers, one-touch keys or the address
book. Chain dial keys can be used as well.
* If you entered the destination fax number with a
one-touch key or a chain dial key, press the “TX setting”
key after that.
(inch)
(metric)
Sending Documents at a Specified Time (Communication Using the Timer)
1 2