Filter
Top Products
Section 10 Reference Information
10-7
When a communications error occurs, one of the following error codes will be printed out on the corresponding Transmission Report or
Reception Report as well as the Activity Report.
Refer to the following tables for a more detailed explanation of the error.
* If an error occurs during communication at a transmission speed of 33600 bps, the “U” in the error codes noted below will change to an “E”.
Error Code Tables
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
Busy The line is busy or the other party does not answer after automatically redialing the set number of times.
Perform transmission or reception procedures again.
Stopped Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
During multiple communication (Broadcast Transmission, Polling Reception, etc.), this unit was unable to
transmit to all destinations due to a communications interruption.
U00300 The destination FAX has run out of recording paper. Check with the destination party.
U00420 - U00462 Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted
because the transmitting party does not possess the necessary communication capabilities.
U00600 - U00690 Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures
again.
U00700 Communication was interrupted due to trouble with the other party’s FAX unit. Check with the other party.
U00800
U00810
Unsuccessfully transmitted page(s) remain. Perform transmission procedures again.
U00900
U00910
Unsuccessfully received page(s) remain. Perform reception procedures again.
U01000 - U01092 A communication error occurred during transmission. Perform transmission procedures again.
U01100 - U01199 A communication error occurred during reception. Perform reception procedures again.
U01400 A communication which uses the timer was scheduled, and a number was entered using an abbreviated number
or one-touch key, etc., but communication with that party was impossible because that number was no longer
registered when the scheduled time arrived. Check your unit.
Or, communication with that party was impossible because the number included a pound sign (#) and it was
registered with the Line Type setting set to “Tone Line”, but the Line Type setting had been changed to “Pulse
Line” at the time you attempted that communication.
U01500 A communication error occurred during transmission at high transmission speed. Perform transmission
procedures again.