Filter
Top Products
Control Panel Options
Control Panel Options
102
14177L-003 APL-I Reference Guide 11/24/09
33
3
ERROR ON PAUSE
When this option is enabled and the print engine
is paused, the print engine sets the applicator
error state.
3
3
START PRINT SIG
This allows you to determine how the printer
reacts to the Start Print Signal input on pin 3 of
the applicator interface.
Password protected.
33
3
RESYNCH MODE
This allows you to determine how the printer
reacts if the label synchronization is lost and the
label top is not where is should be.
Password protected.
3
RIBBON LOW MODE
When the amount of ribbon on the supply
spindle reaches the specified length, the output
signal asserts HIGH to provide a RIBBON
LOW warning.
3
RIB LOW OUTPUT
This is dependent on the setting of RIBBON
LOW MODE
. If RIBBON LOW MODE is
enabled this is asserted HIGH and the amount of
ribbon remaining on the supply spool is below a
specific threshold level.
If
RIBBON LOW MODE is disabled, this output
lead is disabled.
333333
WEB S.
This is automatically set during calibration.
Password protected.
Important • If this needs to be changed, the
change should be done by a a qualified service
technician.
33333
3
MEDIA S.
This is automatically set during calibration.
Password protected.
Important • If this needs to be changed, the
change should be done by a qualified service
technician.
333333
RIBBON S.
This is automatically set during calibration.
Password protected.
Important • If this needs to be changed, the
change should be done by a qualified service
technician.
Table 3 • Control Panel Differences on Supported Printers (Continued)
XiIIIPlus
Z4Mplus/Z6Mplus
105SL
ZM400/ZM600
PAX4
Xi4
Control Panel Option Details and Menu Choices