Filter
Top Products
35
Commands
Configuration Commands
11/24/09 APL-I Reference Guide 14177L-003
Configuration Commands
Amount of Storage, Define
Purpose To determine the amount of RAM that is allocated for storage.
Syntax
<SI>N
Partially Supported Based on testing, this is a partially supported command with the
following differences and outputs:
• This command does not define the amount of memory in the printer because this is
done by the hardware. However, when this command is executed, user-defined
formats, fonts, and graphics are erased from memory.
Auto-Transmit 1, Enable
Purpose To enable auto-transmit 1.
Syntax
<ESC>j
Partially Supported Based on testing, this command is partially supported on the Zebra
printer with APL-I firmware with the following differences and outputs:
• Error messages not supported: The
takeup reel full error is not
transmitted by this command, but all other error messages are.
Auto-Transmit 2, Enable
Purpose To enable auto-transmit 2.
Syntax
<ESC>d
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes With auto transmit level 2 enabled, the printer transmits the status code indicating
there is room in the input buffer:
<DC1> = when using APL-I handshaking protocol
<DC2> = when using XON/XOFF handshaking protocol
Without level 2 enabled, the host must determine the status using alternate commands (
<VT>
or
<ENQ>).