Filter
Top Products
Commands
Test and Service Commands
86
14177L-003 APL-I Reference Guide 11/24/09
Test and Service Mode, Exit
Purpose To make the printer exit Test and Service mode.
Syntax
R
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Transmissive Sensor Value, Transmit
Purpose To send the label gap transmissive sensor and output back to the host.
Syntax G
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Intermec 3400D Printer Label