Filter
Top Products
39
Commands
Configuration Commands
11/24/09 APL-I Reference Guide 14177L-003
Label Rest Point, Adjust
Purpose To adjust where labels stop for removal when the printer is configured for
non-continuous media.
Syntax
<SI>fn
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes You can enable this control through the control panel.
Default: n = 0
Values for n: -30 (backwards) to +30 (forward) in 5 mil increments
Label Retract, Enable or Disable
Purpose To turn on or off the label retract feature when the printer is configured for
continuous media.
Syntax
<SI>Rn
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Things to be aware of:
Default: n = 1
Values for n:
0 = disables label retract
1
= enables label retract