Filter
Top Products
Commands
Program Mode Commands
48
14177L-003 APL-I Reference Guide 11/24/09
Codabar
Purpose To specify a Codabar bar code field.
Syntax
c4,m
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Things to be aware of:
•The c4 command has one argument, m for mode, which defaults to 0.
Default: m - 0
Values for m: m = 0
• The Codabar bar code supports these modes:
m Codabar Mode
0 User provides start/stop codes, which are verified by printer.
1,x,y Printer provides start code x and stop code y, where x and y are values with
ranges of A to D and a to d.
• You can send the start/stop characters as part of the human readable field of the bar
code or as a separate text field (print data). Characters sent down as printer data
override start/stop characters defined by the bar code field.
Code 11
Purpose To specify a Code 11 bar code field.
Syntax
c5,m
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Things to be aware of:
•The
c5 command has one argument, m for mode, which defaults to 0.
Default: m = 0
Values for m:
• The Code 11 bar code supports these modes:
m Code 11 Mode
0 Printer provides two check digits.
1 Printer provides one check digit.
2 User provides two check digits, which are verified by the printer.
3 User provides one check digit, which is verified by the printer.