Filter
Top Products
Commands
Configuration Commands
36
14177L-003 APL-I Reference Guide 11/24/09
Auto-Transmit 3, Enable
Purpose To enable auto-transmit 3.
Syntax
<ESC>e
Partially Supported Based on testing, this command is partially supported on the Zebra
printer with APL-I firmware with the following differences and outputs:
• Error messages not supported: The
imager overrun, printing
complete
, and buffer empty errors are not transmitted by this command, but
all other error messages are.
Auto-Transmit 1, 2, and 3, Disable
Purpose To disable auto-transmit 1, 2, and 3.
Syntax
<ESC>k
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes This command turns off the auto transmit status responses.
Cutter, Enable or Disable
Purpose To enable or disable the cutter option.
Syntax
<SI>cn
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes With the cutter option installed, this command turns the cutter on or off.
Default Value: n = 0
Values for n:
0 = Turns cutter off
1 = Turns cutter on