Filter
Top Products
41
Commands
Configuration Commands
11/24/09 APL-I Reference Guide 14177L-003
Maximum Label Length, Set
Purpose To identify the maximum label length.
Syntax
<SI>L
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes This command is primarily used for detecting media errors.
Media Sensitivity, Select
Purpose To choose the printers media sensitivity.
Syntax
<SI>gn,m
Partially Supported Based on testing, this command is partially supported on the Zebra
printer with APL-I firmware with the following differences and outputs:
• The first argument sets the media type; when n =
0, direct thermal media is selected,
and when n =
1 thermal transfer media is selected.
• The second argument of this command is not used.
Message Delay, Set
Purpose To determine the delay between transmissions.
Syntax
<ESC><SYN>n
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes This command determines the delay in milliseconds before all printer transmissions
begin.
Default: n = 0
Values for n: 0 - 9999