Filter
Top Products
Commands
Configuration Commands
42
14177L-003 APL-I Reference Guide 11/24/09
Number of Image Bands, Set
Purpose To determine the number of image bands.
Syntax
<SI>I
Partially Supported Based on testing, this command is partially supported on the Zebra
printer with APL-I firmware with the following differences and outputs:
• the number of image bands does not need to be set with this command since this
quantity is automatically calculated while printing a label.
Postamble, Set
Purpose To determine the character that is sent before every transmission.
Syntax
<EOT>n
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Assigns the Postamble character.
Default: n = <NUL>
Values for n: Any ASCII character
With n equal to default value, a postamble character is not sent by the printer.
Preamble, Set
Purpose To determine the character that is sent before every transmission.
Syntax
<SOH>n
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Assigns the Postamble character.
Default Value: n = <NUL>
Values for n: Any ASCII character
With n equal to default value, a preamble character is not sent by the printer.