Filter
Top Products
Commands
Configuration Commands
44
14177L-003 APL-I Reference Guide 11/24/09
Self-Strip, Enable or Disable
Purpose To enable or disable the self-strip feature.
Syntax
<SI>tn
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Activates or deactivates the peel sensor.
Default: n = 0
Values for n:
0 = Peel Sensor Off
1
= Peel Sensor On
Top of Form, Set
Purpose To set the form top position.
Syntax
<SI>Fn
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes Sets the label top position in 5 mil increments from the position to the lead edge of the
label.
Default: n = 20
Values for n: -10 to 4000
Negative values allow you to minimize the distance between the print and edge of the label.