Filter
Top Products
Commands
Test and Service Commands
80
14177L-003 APL-I Reference Guide 11/24/09
Test and Service Commands
Ambient Temperature, Transmit
Purpose Transmits the ambient temperature sensor output back to the host.
Syntax
A
Partially Supported Based on testing, this command is partially supported on the Zebra
printer with APL-I firmware with the following difference and output:
The Zebra printer transmits the Fahrenheit temperature back to the host.
The 3400D printer transmits the A/D sensor output back to the host.
Command Terminator
Purpose To end all commands in Test and Service mode.
Syntax
;
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Dark Adjust
Purpose To change the darkness of the print on labels.
Syntax
K
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Factory Defaults, Reset
Purpose To set the printer configuration to the factory defaults.
Syntax
D
Supported Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.