Filter
Top Products
Maintaining disk drives
Issue 2.0 June 2004 111
23. Enter the following commands:
setenv auto-boot? false
reset-all
The system reboots to the ok prompt.
24. Enter:
probe-scsi
This verifies that the system recognizes all of the disk devices, including the newly
installed ones. A message that is similar to the following example is displayed:
The devices listed depends on the number of disks that are installed in the system.
25. Enter the following commands:
!
CAUTION:
CAUTION: If you fail to enter these commands, any reboots that you do in the future will
stop at the boot prompt instead of proceeding through the normal boot-up
process.
setenv auto-boot? true
boot -r
The system reboots.
26. Log in as root.
27. Continue with Setting up replacement disk drives
on page 112.
LiD HA LUN --- Port WWN --- -----Disk description -----
0 0 0 21000004cf72f08f SEAGATE ST373405FSUN3660438
1 1 0 21000004cf721553 SEAGATE ST373405FSUN3660438
6 6 0 508002000016b5b1 SUNW SUNWGS INT FCBPL9224
3 3 0 21000004cf72114b SEAGATE ST373405FSUN3660438
4 4 0 21000004cf7211ae SEAGATE ST373405FSUN3660438