Filter
Top Products
Maintaining PCI cards
Issue 2.0 June 2004 67
9. Carefully pull the card from the I/O board. See the following figure.
10. A message similar to the following is displayed in the console window:
11. Place the card on an antistatic mat or in an antistatic bag.
12. Do one of the following:
● If you are replacing the card, continue with Installing a hot-plug PCI card on
page 68.
● If you are not replacing the card, install a filler panel into the system rear panel,
rotate the purple PCI retaining clip over the back of the filler panel until it snaps into
place, remove the ESD wrist strap, close the side door, and return the key switch to
its original position.
Jun 6 12:55:24 sys_name picld[98]: Device PCI1_CARD removed