Filter
Top Products
Maintenance
80 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting
Maintaining HSI/P cards
An HSI/P card supports X.25 switch links. For eight links, two HSI/P cards and two quad
cables are needed. If the system uses TCP/IP signaling for all links, HSI/P cards are not
needed. HSI/P cards are not supported beginning with CMS R12.
!
Important:
!
Important:
Important: The HSI/P card does not support hot-plug operation. You must shut down
the system and turn off power before installing or replacing a card.
This section includes the following topics:
● Replacing an HSI/P card on page 80
● Installing the first HSI/P card or a pair of HSI/P cards on page 85
● Installing HSI/P software and patches on page 88
● Setting up the switch link for each ACD on page 88
● Adding a second HSI/P card on page 90
If you are replacing a defective HSI/P card, see Replacing an HSI/P card
on page 80. If
this is the initial installation of one or two HSI/P cards, start with Installing the first HSI/P
card or a pair of HSI/P cards on page 85. If a second HSI/P card is being added to a
system already in operation, see Adding a second HSI/P card
on page 90.
Replacing an HSI/P card
To replace an HSI/P card:
1. Log in to the system as root.
2. Enter:
cfgadm
This displays the PCI card configuration before you replace a card. Recheck the
configuration after you have replaced the card.
3. Enter:
/usr/sbin/shutdown -y -i0 -g0
This shuts down the system.
4. Press and release the front panel power button to turn off the system.
Wait for the front panel Power/OK LED to turn off.