Filter
Top Products
Maintaining PCI cards
Issue 2.0 June 2004 79
13. Insert the new Dual Ethernet and Dual SCSI card into the slot on the I/O board. Make
sure that the card is fully seated. See the following figure.
14. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps
into place.
15. Remove the ESD wrist strap.
16. Close the left door.
17. Reattach the cables.
18. Turn on any external SCSI devices, starting with the device that is farthest from the
system and working toward the system.
19. Turn on the system monitor.
20. Turn on the system.
21. When the system comes back up, log in as root.
22. Enter:
cfgadm
This displays the PCI card configuration after you replace the card. Make sure that the
new card is displayed.