Filter
Top Products
Turning on the system and verifying POST
Issue 2.0 June 2004 35
Turning on the system and verifying POST
Once you assemble the system, including the loose hardware that is shipped with the
system that you installed with help from CMS Provisioning, turn on the system and verify
the results of the Power-On Self Test (POST).
To turn on the system and verify POST:
1. Verify that the key switch is in the Forced Off position. See the following figure.
2. If using one or more UPSs, plug the power cord of each UPS into a dedicated circuit. If
not using a UPS, plug the power cords for each power supply into an outlet on a
dedicated 15-amp circuit.
3. Turn on the power to the UPS units, if UPS units are installed.
4. Turn on the system monitor.