Filter
Top Products
Replacing a power supply
Issue 2.0 June 2004 149
7. Slowly slide the new power supply into its bay until the connectors on the power supply
are fully engaged with the connectors on the power distribution board. See the
following figure.
8. Tighten the two captive screws that secure the power supply to the chassis.
9. Connect the AC power cord to the power supply. Insert the power cord through the
strain-relief tie-wrap loop, located to the right of the supply. Tighten the tie-wrap to
secure the connection.
Note:
Note: You can also replace a power supply when the system is at the boot level
(that is, the ok prompt is displayed). If a power supply is replaced at the boot
level, you must reboot the system using the reset-all command.