Filter
Top Products
Maintaining PCI cards
Issue 2.0 June 2004 69
9. Insert the PCI card into the slot on the I/O board. Make sure that the card is fully
seated. See the following figure.
When the card is inserted, the amber OK-to-Remove LED lights and a message similar
to the following is displayed on the console window:
10. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps
into place.
11. Press the hot-plug button for the card you are installing.
After the button is pressed, the following should occur:
● The amber Fault LED for the slot may blink briefly and then turn off.
● The green Power LED lights.
● A message similar to the following is displayed on the console window:
!
Important:
!
Important:
Important: If the Fault LED remains off or stays lit after inserting a card, you must shut
down the system, reinsert the card, and reboot the system.
Jun 6 12:55:24 sys_name picld[98]: Device PCI1_CARD inserted
Jun 6 12:57:11 sys_name pcihp: NOTICE: pcihp (pcisch0): card is
powered on in the slot hpc1_slotX