Filter
Top Products
Turning on the system and verifying POST
Issue 2.0 June 2004 37
9. Enter:
probe-scsi-all
This verifies that the system sees the disk drives and backplane, the tape drive, and
the DVD-ROM drive. A message that is similar to the following is displayed:
10. Verify that all of the devices are recognized. If the devices are not recognized, see
Troubleshooting disk drives and DVD-ROM drives
on page 180 for more information.
11. When you have verified that the system recognizes all of its devices, enter the
following commands:
!
CAUTION:
CAUTION: If you fail to reset the auto-boot option, any reboots that you do in the future
will stop at the boot prompt instead of proceeding through the normal
boot-up process.
setenv auto-boot? true
boot
The system reboots.
/pci@8,600000/SUNW,qlc@2
LiD HA LUN --- Port WWN --- -----Disk description -----
0 0 0 21000004cf72f08f SEAGATE ST373405FSUN3660438
1 1 0 21000004cf721553 SEAGATE ST373405FSUN3660438
6 6 0 508002000016b5b1 SUNW SUNWGS INT FCBPL9224
3 3 0 21000004cf72114b SEAGATE ST373405FSUN3660438
4 4 0 21000004cf7211ae SEAGATE ST373405FSUN3660438
/pci@8,700000/scsi@1
Target 5
Unit 0 Removeable Tape HP C5683A C005
Target 6
Unit 0 Removeable Read Only device TOSHIBA DVD-ROM SD-M14011009
/pci@8,700000/pci@5/SUNW,1sptwo@4