Filter
Top Products
Tools
Issue 2.0 June 2004 173
7 controller@0,16 Tests the base backplane firmware and SSC-100 SES
controllers.
8 controller@0,1a
9 controller@0,1c Tests the expansion backplane firmware and SSC-100
SES controllers. Use only on 12-disk systems.
10 controller@0,1e
11 ebus@1 Tests the PCI configuration registers, DMA control
registers, ebus mode registers, and DMA controller
functions.
12 flashprom@0,0 Performs a checksum of the flash PROM containing the
OpenBoot firmware.
13 gpio@1,300600 Tests the registers of the super I/O subsystem.
14 hot plug-controller@0, Performs a hot-plug test of the PCI slots.
!
CAUTION:
CAUTION: After the hot-plug test, the PCI cards in the
slots are not usable until you reset the
system.
15 hot plug-controller@0,
16 hot plug-controller@0,
17 hot plug-controller@0,
18 i2c@1,2e Tests the devices monitored by the I
2
C environmental
monitoring bus (temperature sensors, fans, power
supplies, system fault LEDs, thermal fault LEDs, and front
panel key switch).
19 i2c@1,30
20 i2c@1,50002e
21 i2c@1,500030
22 keyboard@1 Tests the USB keyboard.
23 network@1 Tests the on-board Gigabit Ethernet (GBE) logic, including
internal and external loopback tests.
24 network@1,1 Tests the on-board Fast Ethernet logic, including internal
and external loopback tests.
25 pmc@1,300700 Tests the registers of the power management controller.
26 rsc-control@1,3062f8 Tests RSC hardware, including RSC serial and Ethernet
ports.
27 rtc@1,300700 Tests the registers of the real-time clock and then tests the
interrupt rates.
28 scsi@1 Tests the on-board SCSI controller and SCSI bus
subsystem for internal removable media devices. Checks
associated registers and performs a DMA transfer.
Command
number
Command name Description