Filter
Top Products
Replacing the RSC card
Issue 2.0 June 2004 97
14. Insert the faceplate end of the new RSC card into the appropriate opening in the rear
panel.
See the following figure.
15. Insert the opposite end of the card into the appropriate card guide so that the RSC
card is aligned evenly with the connectors on the I/O board.
16. Push the card into the connectors on the system I/O board, applying even pressure
along the edge of the card.
17. Secure the RSC card faceplate to the rear panel with the Phillips screw.
18. Connect the Ethernet, serial, and modem cables to the appropriate connector on the
RSC card.
19. Reconnect the AC power cords to the power supplies.
20. Remove the ESD wrist strap.
21. Close the side door.