Filter
Top Products
3-14
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter3 Site Preparation
Seismic Considerations
Seismic Considerations
To secure a Cisco-supplied cabinet, holes in the upper and lower corners accommodate 3/8" or 1/2" bolts.
Also, an optional stability plate can be purchased with the Cisco cabinet. The stability plate is bolted to
the floor, then the Cisco cabinet is bolted to the stability plate. Instructions for installing the stability
plate appear in the section “Seismic Anchoring for a Cisco Rack.”
Seismic Anchoring for a Cisco Rack
This section describes how to install the Cisco cabinet with the optional stability plate for seismic
anchoring.
To set up the Cisco cabinet with the stability plate, perform the following:
Step 1 Use the dimensions in Figure 3-1 to drill the holes for installing the stability plate.
Step 2 Remove the stability plate from the base of the Cisco cabinet. Save these nuts and bolts.
Step 3 With the user-provided anchoring bolts, attach the stability plate to the floor.
Step 4 Roll the Cisco cabinet over the stability plate as Figure 3-2 illustrates.
Step 5 Use the nuts and bolts from the shipping setup to secure the cabinet to the stability plate.
Avvertenza
Non fissare il raggio con gli occhi né usare strumenti ottici per osservarlo direttamente.
Advarsel
Stirr eller se ikke direkte pŒ strŒlen med optiske instrumenter.
Aviso
Não olhe fixamente para o raio, nem olhe para ele directamente com instrumentos ópticos.
¡Advertencia!
No mirar fijamente el haz ni observarlo directamente con instrumentos ópticos.
Varning!
Rikta inte blicken in mot strålen och titta inte direkt på den genom optiska instrument.