Filter
Top Products
Index
IN-5
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
from AUSM/B line 6-14
O
on-line firmware, see run-time firmware 5-4
overview of MGX 8220 1-2
P
PAR
resource partitioning on PXM
5-6, 6-2
physical line
activating through the CLI on PXM
5-10
physical lines
activation, PXM
6-5
Portable AutoRoute, see PAR 5-6, 6-2
power entry module 1-7
power requirements 3-2
Power system in MGX 8230 1-6
PXM
creating logical ports through the CLI
5-10
front card installation, warnings 2-1
port 34 5-11
port-level resource partitioning 5-11
specifying IP addresses 5-4
PXM1
Processor Switching Module
1-12
PXM1-UI
Processor Switch Module User Interface
1-13
PXM cell bus
Also see PXM
1-10
PXM-UI
alarm outputs
2-6
installation 2-1
user-control and access ports 5-3
PXM User Interface back card, see PXM-UI 2-1
R
reboot command 5-5
receive direction, relative to MGX 8230 B-1
redundancy
1 to N for AUSM T1 and E1
6-14
FRSM E1 mode 6-27
FRSM T1 mode 6-27
redundancy back cards
R-RJ48-8E1
6-43
R-RJ48-8T1 6-43
Related documentation for IGX 8450 xxii
remoteConnId 6-11
Remove 4-7
Removing back cards 4-8
Removing front cards 4-7
resource partitioning
definition
6-1
definition for PXM 5-6
port-level, PXM 5-11
RJ48-8E1 6-43
RJ48-8T1 6-43
Route Processor Module
RPM
1-15
RPM
Route Processor Module
1-15
R-RJ48-8E1 6-43
R-RJ48-8T1 6-43
run-time firmware, see firmware download 5-4
S
safety
power and ground
3-17
SAFETY GROUND 4-12
seismic mounting 3-14
seismic stability plate 3-14
serial line interface protocol, see SLIP 5-3
service interworking 2-24