Filter
Top Products
6-15
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter6 Card and Service Configuration
ATM Universal Service Module (AUSM)
Configure the Card, Lines, and Ports
You can activate and configure the AUSM card, lines, and ports with either the CLI or the CiscoView
application. This section includes descriptions of the CLI commands used to perform the following
tasks:
• Optionally modify resource partitioning at the card level
• Activate and configure a line
• Create and configure a logical port
• Optionally modify resource partitioning at the port level
• Configure usage parameters
• Configure queue depths
• Configure the ForeSight ABR feature
• Configure standard ABR
• Configure a line as a clock source
Note For connection-related tasks, see Adding and Configuring Connections on the AUSM/B,
page 6-17.
On the CLI of the AUSM/B:
Step 1 If necessary, modify the resource partitioning for the whole card by executing the cnfcdrscprtn
command. You can view resource partitioning through dspcdrscprtn.
cnfcdrscprtn <number_PAR_conns | number_PNNI_conns | number_TAG_conns>
• number_PAR_conns is the number of connections in the range 0–1000 for PAR.
• number_PNNI_conns is the number of connections in the range 0–1000 for PNNI.
• number_TAG_conns is the number of connections in the range 0–1000 for MPLS.
For example, you could reserve 300 connections for each controller on the AUSM with:
cnfcdrscprtn 300 300 300
Step 2 Activate a physical line by using addln for each of the eight lines as needed:
addln <line_number>
Step 3 Optionally, use the cnfln command to specify line coding, line length, and clock source:
cnfln <line_num> <line_code> <line_len> <clk_src> [E1-signaling]
Step 4 Execute upport to activate the logical operation of the line:
upport <port_number>, where port_number is in the range 1–8.
Step 5 If necessary, execute cnfportq to modify the egress queues:
cnfportq <port_num> <q_num> <q_algo> <q_depth> <clp_high> <clp_low> <efci_thres>