Filter
Top Products
4-2
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter4 Enclosure Installation
Installing a Stand-Alone MGX 8230
Installing a Stand-Alone MGX 8230
If the switch is a stand-alone unit, proceed directly to:
• Connecting Power for DC Systems, page 4-11
• Connecting Power for AC Systems, page 4-14.
If a lift is not available and the cards need to be removed, review the appropriate instructions to remove
and replace modules in the “Install the MGX 8230 Without a Mechanical Lift (Optional)” section on
page 4-7.
Rack Mounting an MGX 8230
To install the MGX 8230 into a 19- or 23-inch rack, follow the instructions outlined below:
• Prepare for Rack Installation, page 4-3.
• Install the MGX 8230 Using a Mechanical Lift (Recommended), page 4-6.
• Install the MGX 8230 Without a Mechanical Lift (Optional), page 4-7.
• Connecting Power for DC Systems, page 4-11.
• Connecting Power for AC Systems, page 4-14.
• Install the Cable Manager, page 4-17.
• Power up the MGX 8230, page 4-18.