Filter
Top Products
6-16
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter 6 Card and Service Configuration
ATM Universal Service Module (AUSM)
Step 6 If necessary, configure resources at the port level by executing cnfportrscprtn. Use dspportrscprtn to
see the current resource partitioning.
cnfportrscprtn <port_num> <controller> <ingress_%BW> <egress_%BW> <number_of_cons>
<VPImin/VPImax> [VCImin/VCImax]
• port_num is the logical port number in the range 1–8.
• q_num is the queue number in the range 1–16; 0 is the default for addchan.
1=CBR
2=VBR
3=ABR
4=UBR
• q_algo is a number to specify the queue algorithm:
0=disable queue
1=high priority—always serve
2=best available
3=minimum guaranteed bandwidth
4=minimum guaranteed bandwidth with maximum rate shaping
5=CBR with smoothing
• q_depth is the maximum queue depth in the range 1–16000 cells.
• clp_high is the high cell loss priority in the range 1–16000 cells.
• clp_low is the low cell loss priority in the range 1–16000 cells.
• efci_thres is the EFCI threshold in the range 1–16000 cells.
• port_num is the port number in the range 1–8.
• controller is a number representing the controller: 1=PAR, 2=PNNI, and
3=MPLS.
• ingress_%BW is the percentage of ingress bandwidth in the range 0–100.
• egress_%BW is the percentage of egress bandwidth in the range 0–100.
• number_of_cons is the maximum number of connections on the port.
• VPImin/VPImax is the minimum and maximum VPI numbers.
• VCImin/VCImax is the optional specification for VCI range.