Filter
Top Products
2-47
Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter 2 Module and Service Descriptions
Frame Relay Service Modules
STBY LED (Standby) Yellow Slow blink without the Active LED indicates the card
is in the boot state.
Fast blink with the Standby LED indicates the card is
being downloaded.
Fast blink indicates the service module is passing
BRAM channel information to the PXM1
Steady yellow indicates the card is in Standby mode
and the firmware is executing ADMIN code.
FAIL LED Red Steady Red with Active and Standby LEDs off
indicates either the card is in the Reset condition, the
card has failed, or the card set is not complete (no line
module).
Steady Red with Active LED on indicates the card was
active prior to failing.
Steady Red with Standby LED on indicates the card
was standby prior to failing.
Both standby and red LED lit indicates self-test failure.
Table 2-13 LED Indicators for Eight-Port CESM (continued)
Type of LED Color Meaning