Filter
Top Products
4–2 Configuring Storagesets
Introduction
One method of configuring storagesets is manual configuration. This method allows
you the most flexibility in defining and naming storagesets. See Chapter 5, “CLI
Commands,” for complete information about the CLI commands shown in this
chapter.
Adding Disk Drives
The factory-installed devices in your StorageWorks subsystem have already been
added to the controller’s list of eligible devices. If you want to add new devices to
your subsystem, you must issue one of the following CLI commands before you can
use them in any kind of storageset, single disk unit, or spareset:
ADD DISK
RUN CONFIG
Adding One Disk Drive at a Time
To add one new disk drive to your controller’s list of eligible devices, enter the
following command at the prompt:
ADD DISK DISKnnnn ptl-location switch_value
Adding Several Disk Drives at a Time
To add several new disk drives to your controller’s list of eligible devices, enter the
following command at the prompt:
RUN CONFIG