Filter
Top Products
4–14 Configuring Storagesets
2. Verify the contents of the spareset using the following syntax:
SHOW SPARESET
Example
The following example shows the commands you would use to add DISK60000 and
DISK60100 to the spareset.
ADD SPARESET DISK60000
ADD SPARESET DISK60100
SHOW SPARESET
Removing a Disk Drive from the Spareset
You cannot delete the spareset—it always exists whether or not it contains disk drives.
However, you can delete disks in the spareset if you need to use them elsewhere in
your StorageWorks subsystem.
To remove a disk drive from the spareset:
1. Show the contents of the spareset using the following syntax:
SHOW SPARESET
2. Delete the desired disk drive using the following syntax:
DELETE SPARESET DISKnnnn
Verify the contents of the spareset using the following syntax:
SHOW SPARESET