Filter
Top Products
5–44 CLI Commands
CONFIGURATION RESET
Erases the entire configuration on “this controller,” restores the controller’s default
configuration, and shuts down the controller.
NOTE: If you plan to use this feature, SAVE_CONFIGURATION must be set when you
initialize the container. See “INITIALIZE,” page 5–62.
Specify the CONFIGURATION RESET command on “this controller” in nofailover
mode only. Enter this command to ensure all of the old configuration information is
removed when a controller is moved from one subsystem to another.
This command disables communication between host and controller. Enter new
configuration information through the SET THIS_CONTROLLER command or the
CONFIGURATION RESTORE command to make the controller operational.
You can also initiate the CONFIGURATION RESET command from the controller’s
operator control panel (OCP) by holding in port button 5 and pressing the reset
button.
Syntax
CONFIGURATION RESET
See also
CONFIGURATION RESTORE
CONFIGURATION SAVE
INITIALIZE