Filter
Top Products
5–109
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
Disks that you plan to use for AUTOSPARE must not have valid metadata on them. If
you suspect a disk does have metadata on it (it was used in a stripeset or was
initialized as NOTRANSPORTABLE) you must use the following steps to make the
disk available as a spareset replacement disk:
These steps use DISK10000 as an example.
1. Delete all containers to which the disk belongs.
2. Make the disk transportable.
SET DISK10000 TRANSPORTABLE
3. Initialize the disk.
INIT DISK10000
4. Delete the disk.
DELETE DISK10000
5. Remove DISK10000 from the cabinet until it is time to replace a failed disk.
Example
This example shows how to enable the automatic spare feature:
SET FAILEDSET AUTOSPARE
This example shows how to disable the automatic spare feature:
SET FAILEDSET NOAUTOSPARE
See also
DELETE FAILEDSET
SHOW FAILEDSET