Filter
Top Products
4–36 Configuring Storagesets
Use the following procedure to move a storageset while maintaining the data it
contains:
1. Show the details for the storageset you want to move. Use the following syntax:
SHOW storageset-name
2. Physically label each member with its name and PTL location.
If you do not have a storageset map for your subsystem, you can enter the LOCATE
command for each member to find its PTL location. Use the following syntax:
LOCATE disk-name
To cancel the locate command, use the following syntax:
LOCATE CANCEL
3. Delete the unit-number shown in the “Used by” column of the SHOW storageset-
name command. Use the following syntax:
DELETE unit-number
4. Delete the storageset shown in the “Name” column of the SHOW storageset-
name command. Use the following syntax:
DELETE storageset-name
5. Delete each disk drive—one at a time—that the storageset contained. Use the
following syntax:
DELETE disk-name
DELETE disk-name
DELETE disk-name
6. Remove the disk drives and move them to their new PTL locations.
7. Add each disk drive to the controller’s list of valid devices. Use the following
syntax:
ADD DISK disk-name PTL-location
ADD DISK disk-name PTL-location
ADD DISK disk-name PTL-location