Filter
Top Products
5–68 CLI Commands
DISKS
Causes the green device fault LEDs of all configured disks to flash. Enter LOCATE
CANCEL to turn off the LEDs.
PTL (SCSI-location)
Causes the green device fault LED on the device at the given SCSI location to flash.
See “Device PTL Addressing Convention within the Controller,” page 3–36, for an
explanation of the PTL addressing naming format.
Not all devices have a device fault LED. Therefore, they do not appear to respond to
the LOCATE command.
UNITS
Causes the green device fault LEDs of all devices used by the units to flash. This
command is useful to determine which devices are not currently configured into
logical units. Enter LOCATE CANCEL to turn off the device fault LEDs.
container-name
Causes the amber device fault LEDs on the devices within the container-name to
flash. If a device name is given, the device's fault LED is turned on. If a storageset
name is given, the fault LED on all of the devices assigned to the storageset turns on.
Use LOCATE CANCEL to turn off the LEDs.
unit-number
Causes the green device fault LEDs on the devices making up the unit-number to
flash. Use LOCATE CANCEL to turn off the LEDs.