Filter
Top Products
4–15
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
Example
The following example shows the commands you would use to remove DISK60000
from the spareset.
SHOW SPARESET
DELETE SPARESET DISK60000
SHOW SPARESET
Enabling Autospare
With AUTOSPARE enabled on the failedset, any new disk drive that is inserted into
the PTL location of a failed disk drive is automatically initialized and placed into the
spareset. If initialization fails, the disk drive remains in the failedset until you
manually delete it from the failedset.
To enable autospare, use the following syntax:
SET FAILEDSET AUTOSPARE
To disable autospare, use the following syntax:
SET FAILEDSET NOAUTOSPARE
During initialization, AUTOSPARE checks to see if the new disk drive contains
metadata—the information that indicates it belongs to, or has been used by, a known
storageset. If the disk drive contains metadata, initialization stops. A new disk drive
will not contain metadata, but a repaired or re-used disk drive might. To erase
metadata from a disk drive, add it to the controller’s list of devices, then set it to be
TRANSPORTABLE and initialize it.
Name Storageset Uses Used by
SPARESET spareset disk60000
disk60100
Name Storageset Uses Used by
SPARESET spareset disk60100