5–102 CLI Commands
SET
device-name
Changes the transportable characteristics and the maximum data transfer rate between
the controller and the specified device.
Syntax
SET device-name
Parameter
device-name
Specifies the name of the device to change. This can be a previously named device,
disk, passthrough device, or container.
Switches
LOCAL (Default)
REMOTE
Specifies the disk characteristics in a mirrorset, either local or remote.
■ Disks set to REMOTE can only be added to mirrorsets and JBOD (that is, not
RAID5 raidsets).
■ Disks set to REMOTE can only be added to mirrorsets that are set to
DT_SUPPORT.
■ Disks set to LOCAL can be added to mirrorsets that are set to either
NODT_SUPPORT or DT_SUPPORT.
■ Disks set to REMOTE that are part of a mirrorset will not be the read source.
■ Setting the switch to REMOTE forces a disk to be NOTRANSPORTABLE.