Filter
Top Products
3–4 Creating Storagesets
Planning and Configuring Storagesets
Use this procedure to plan and configure the storagesets for your subsystem. Use the
references in each step to locate details about specific commands and concepts.
1. Create a storageset and device profile. See “Creating a Storageset and Device
Profile,” page 3–5 for suggestions about creating a profile.
2. Determine your storage requirements. Use the questions in “Determining Storage
Requirements,” page 3–7 to help you.
3. Choose the type of storagesets you need to use in your subsystem. See “Choosing
a Storageset Type,” page 3–8 for a comparison and description of each type of
storageset.
4. Select names for your storagesets and units. See “Creating a Storageset Map,”
page 3–34 for details about selecting names.
5. Assign unit numbers to storagesets so the host can access the units. See “Node
IDs,” page 3–30 for information about how to assign unit numbers to storagesets.
6. Create a storageset map to help you configure your subsystem. See “Creating a
Storageset Map,” page 3–34 for suggestions about creating a storageset map.
7. If you are going to partition your storagesets, plan the partitions. See “Planning
Partitions,” page 3–40 for information about partitions and how to plan for them.
8. Choose the switches that you will want to set for your storagesets and devices.
See“Choosing Switches for Storagesets and Devices,” page 3–42 for a
description of the switches you can select for storagesets.
9. Configure the storagesets you have planned using one of these methods:
❏ Use StorageWorks Command Console (SWCC) to set up and manage RAID
storage subsystems. See the SWCC Getting Started Guide for details about using
SWCC to configure your storagesets.
❏ Use CLI commands. This method allows you flexibility in defining and nam-
ing storagesets. See “Configuring Storagesets,” page 4–1 for information about
configuring each type of storageset using CLI commands.