Filter
Top Products
5–24 CLI Commands
ADD STRIPESET
Names a stripeset and adds it to the controller configuration. Stripesets are sometimes
referred to as RAID level 0 storagesets. The number of members in the stripeset is
determined by the number of container-name parameters specified.
Syntax
ADD STRIPESET stripeset-name container-name1 container-name2
[container-nameN]
Parameters
stripeset-name
Assigns a name to the stripeset. This is the name used with the ADD UNIT command
to identify the stripeset as a host-addressable unit.
container-name1 container-name2 [container-nameN]
Identifies the members (disk drives or mirrorsets) making up the stripeset. Stripesets
can contain between 2 and 24 members.
The container name must start with a letter (A through Z) and may consist of a
maximum of nine characters including letters A through Z, numbers 0 through 9,
periods (.), dashes (-), or underscores (_).
IMPORTANT: It is common to name a stripeset STRIPE
n
, where n is a sequen-
tially assigned, unique identifier. This naming convention presents to the user
both the type of container and its unique identifier.
NOTE: A 240-character limit exists for the command line. If you are configuring a
stripeset with multiple members (for example, more than 20), you will have to
rename the members in order to execute the command.