Filter
Top Products
5–86 CLI Commands
RUN
Runs a diagnostic or utility program on “this controller.” Diagnostic and utility
programs only run on “this controller.”
Syntax
RUN program-name
Parameter
program-name
The program-name parameter specifies the name of the diagnostic or utility program
to be run. The following programs can currently be run:
■ CHVSN—This is not a user utility. This utility may be used by Compaq
authorized service personnel only.
■ CLCP—A utility used to load updated software code or patches. See Upgrading
the Subsystem in the Maintenance and Service Guide for more information
regarding this utility.
■ CLONE—A utility used to automate the process of mirroring units to create a
snapshot copy of host unit data. See “Cloning Data for Backup,” page 3–20, for
more information regarding this utility.
■ CONFIG—A utility used to locate and add devices to the controller
configuration. CONFIG may be run anytime new devices are added to the
subsystem. See “Adding Disk Drives,” page 4–2, for more information regarding
this utility.
■ DILX—A utility used to test and verify the controller’s operation with attached
storage devices under a high or low I/O load. Run DILX (disk inline exerciser)
only when there is no activity on the controller. The total I/O load is handled by
the controller, bypassing the host.
The DILX utility has two modes, an autoconfigure mode, and a standard mode.