Filter
Top Products
4–4 Configuring Storagesets
Example
The following example shows the commands you would use to create Stripe1, a three-
member stripeset:
ADD STRIPESET STRIPE1 DISK10000 DISK20000 DISK30000
INITIALIZE STRIPE1 CHUNKSIZE=128
ADD UNIT D100 STRIPE1 MAXIMUM_CACHED_TRANSFER=16
SHOW STRIPE1
SHOW D100
Configuring a Mirrorset
See “Creating a Storageset and Device Profile,” page 3–5, for information about
creating a profile and understanding the switches you can set for this kind of storage
unit.
To configure a mirrorset:
1. Create the mirrorset by adding its name to the controller’s list of storagesets and
specifying the disk drives it contains. Optionally, you can append Mirrorset
switch values. If you do not specify switch values, default values are applied.
Use the following syntax to create a mirrorset:
ADD MIRRORSET mirrorset-name DISKnnnn DISKnnnn switch
See “ADD MIRRORSET,” page 5–11, for valid switches and values.
2. Initialize the mirrorset. If you want to set any Initialize switches, you must do so
in this step. Use the following syntax:
INITIALIZE mirrorset-name switch
See “INITIALIZE,” page 5–62, for valid switches and values.