Filter
Top Products
5–126 CLI Commands
REPLACE=disk-name
Instructs the controller to add a disk member to an existing RAIDset if the following
conditions are met:
■ The replacement policy is set to NOPOLICY.
■ The disk member is not in any configuration, including a spareset.
An error is displayed and the command is rejected if the RAIDset is not in a reduced
state, if a replacement policy is already specified, or if the disk specified is already
being used by a configuration (including a spareset).
NOTE: Do not specify other switches when you use the REPLACE switch.
Examples
This example shows how to change the replacement policy for RAIDset RAID9 to
BEST_FIT:
SET RAID9 POLICY=BEST_FIT
This example shows how to remove member DISK10000 from the RAID9 RAIDset:
SET RAID9 REMOVE=DISK10000
If there is a replacement policy, the controller moves a disk from the spareset to the
RAIDset automatically.