Filter
Top Products
4–3
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
Configuring a Stripeset
See “Using Striped Mirrorsets for Highest Performance and Availability,” page 3–18
for information about creating a profile and understanding the switches you can set
for this kind of storage unit.
To configure a stripeset:
1. Create the stripeset by adding its name to the controller’s list of storagesets and
specifying the disk drives it contains. Use the following syntax:
ADD STRIPESET stripeset-name DISKnnnn DISKnnnn
2. Initialize the stripeset. If you want to set any Initialize switches, you must do so
in this step. Use the following syntax:
INITIALIZE stripeset-name switch
See “INITIALIZE,” page 5–62, for valid switches and values.
3. Present the stripeset to the host by giving it a unit number the host can recognize.
Optionally, you can append Unit switch values. If you do not specify switch
values, default values are applied.
ADD UNIT unit-number stripeset-name switch
See “ADD UNIT,” page 5–27, for valid switches and values.
4. Verify the stripeset configuration and switches. Use the following syntax:
SHOW stripeset-name
5. Verify the unit configuration and switches. Use the following syntax:
SHOW unit-number