Filter
Top Products
5–125
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
RECONSTRUCT=FAST
RECONSTRUCT=NORMAL (Default)
Sets the speed at which the controller reconstructs the data on the new RAIDset
member replacing a failed member.
Specify NORMAL to balance other controller operations against the reconstruct
operation. The controller uses relatively few resources to perform the reconstruct, and
there is little impact on performance.
Specify FAST when the reconstruct operation must take precedence over other
controller operations. The controller uses more resources to perform the
reconstruction. Reconstruction takes less time, but overall controller performance is
reduced during the reconstruction.
REMOVE=disk-name
Instructs the controller to remove a member from an existing RAIDset. The disk drive
specified by disk-name is removed from the RAIDset specified by RAIDset-name.
The removed disk drive is added to the failedset.
If a RAIDset is already in a reduced state, an error is displayed and the command is
rejected. If a replacement policy is specified, the replacement is taken from the
spareset to replace the removed member using the policy specified.
If the NOPOLICY switch is specified with the SET RAIDset command, the RAIDset
continues to operate in a reduced state until a replacement policy is specified or the
REPLACE switch is specified. See the REPLACE=disk-name switch for information
on manually replacing a RAIDset member. See the POLICY and NOPOLICY
switches on 5–124 for information regarding setting a policy for automatic member
replacement.
NOTE: Do not specify other switches when you use the REMOVE switch.