Filter
Top Products
2–13
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
8. If you are configuring controllers in transparent failover mode, prefer some or all
SCSI target ID numbers to the controllers. Use the following command:
SET THIS_CONTROLLER PORT_1_PREFERRED_ID = (
n, n
)
or
SET THIS_CONTROLLER PORT_2_PREFERRED_ID = (
n,n
)
where n,n is a subset of the target ID numbers you declared in step 5.
See “Using Preferred ID Numbers,” page 2–35, for details about preferred SCSI
target ID numbers.
9. Set the host function mode for the controller using the target ID numbers set in
step 7 and in step 8. Use the following command:
NOTE: The default host function mode defaults to Host Mode A. The
HOST_FUNCTION switch changes the host function mode to a different mode.
SET THIS_CONTROLLER HOST_FUNCTION= (
ID, MODE
)
or
SET OTHER_CONTROLLER HOST_FUNCTION= (
ID, MODE
)
To change the host function mode, see “SET controller,” page 5–91 for information
on the HOST_FUNCTION switch.
10. Restart the controllers using the following command:
NOTE: After restarting the other controller, the EMU alarm will sound. To stop it,
restart this controller.
RESTART OTHER_CONTROLLER
RESTART THIS_CONTROLLER
See “RESTART controller” in Chapter 5, “CLI Commands.”